Hi,
I am using Ranorex 9.1
I am trying to capture the text inside the "Tooltip" in my application without success.
Following the steps of this tutorial: https://www.ranorex.com/help/latest/ran ... tool-tips/
Here are the steps I am following:
-Start Recording
--Check Enable hotkeys
-Move the mouse over the Control and wait for the "Tooltip" to appear
-Then type "T" on the keyboard to display the dialog box
Result--> The dialog box does not appear.
Thanks ,
Filipe
Enable hotkeys not working
Re: Enable hotkeys not working
Tooltips are 'fun'
I usually end up writing some code to save a snapshot of the entire system at the moment the tooltip I'm trying to capture should be visible. That lets me examine the state of play in Ranorex Spy, allowing me to write a RxPath to the tooltip. IIRC saving a snapshot is possible from a recording, but I don't use recordings so I'm hazy there.
I usually end up writing some code to save a snapshot of the entire system at the moment the tooltip I'm trying to capture should be visible. That lets me examine the state of play in Ranorex Spy, allowing me to write a RxPath to the tooltip. IIRC saving a snapshot is possible from a recording, but I don't use recordings so I'm hazy there.
-
- Posts: 19
- Joined: Tue Jul 16, 2019 3:24 pm
Re: Enable hotkeys not working
Thanks Stub.
I will have to find a workaround because I have the feeling that this will not work.
Regards,
Filipe
I will have to find a workaround because I have the feeling that this will not work.
Regards,
Filipe