Error Module: Failed to move to location 'Center'...

Technology specific object identification, supported applications, web technologies, and 3rd party controls.
Posts: 34
Joined: Mon Sep 24, 2012 9:45 pm
Location: Kansas City

Error Module: Failed to move to location 'Center'...

Post by kdreiling » Tue Jul 12, 2016 5:42 pm

I am executing a test run in a Test Suite, but randomly the test run fails at different locations and not in the same recording without warning. The next time I execute the test run Ranorex fails at a different element on a different recording. It doesn't happen consistently. Then sometimes the test run goes all the way through.

The error being generated is attached. I did some research on the forum and one possible solution indicated, I would need to set Ensure visible where ever this occurs. It isn't abundantly clear what is actually causing this error to happen.

If anyone could share their thoughts, it would be much appreciated.
You do not have the required permissions to view the files attached to this post.

Posts: 107
Joined: Fri Jul 03, 2015 9:18 am

Re: Error Module: Failed to move to location 'Center'...

Post by jma » Wed Jul 13, 2016 3:06 pm

First, it would be helpful to know which version of Ranorex you use?

Please upload the compressed Ranorex Report of the failed test execution. Furthermore, please create a Ranorex Snapshot of the corresponding UI element after the test failed. This will give more detailed information about the used technology and the cause of the issue.