Hello, since the last update to 10.5.1 we have one TestSuite where the html.data file of the report does not contain any data and is empty during and after the test execution. We have that problem with one specific testSuite and new testsuites we try to launch.
Any ideas?
html report does not work
html report does not work
You do not have the required permissions to view the files attached to this post.
Re: html report does not work
Hi, do you control any report properties through the command line? Or only through the UI settings window?
Re: html report does not work
Hi, I start the TestSuite via command line with the following parameters:
/rf:$(BuildName)_$(BuildDateTime).html /pa:ActiveModules=$(Modules) /pa:Branch=$(Branch) /pa:Dev=false /ts:ModuleTests.rxtst
I already tried simpler names for the html report to rule out any characters in the filename that it does not like.
/rf:$(BuildName)_$(BuildDateTime).html /pa:ActiveModules=$(Modules) /pa:Branch=$(Branch) /pa:Dev=false /ts:ModuleTests.rxtst
I already tried simpler names for the html report to rule out any characters in the filename that it does not like.
Re: html report does not work
Thank you for the details, looks like a few users have encountered something similar, the fix is planned for one of the future releases.
Not sure if explicitly specifying another report file as /rf:$(BuildName)_$(BuildDateTime).html.data could temporarily solve the issue.
Not sure if explicitly specifying another report file as /rf:$(BuildName)_$(BuildDateTime).html.data could temporarily solve the issue.
Re: html report does not work
no that did not work, ranorex support says that they are working on it.. lets see
Thanks for your help
Thanks for your help
Re: html report does not work
Ack. Just hit exactly the same issue here too. 0KB .data file. Any chance of following up here if you get news from Ranorex Support?
In the meantime I'm UNinstalling v10.5.3 and going back to v10.1.6. This is yet another showstopper issue for us.
In the meantime I'm UNinstalling v10.5.3 and going back to v10.1.6. This is yet another showstopper issue for us.
Last edited by Stub on Mon Feb 27, 2023 12:19 pm, edited 1 time in total.
Re: html report does not work
yeah I will let you know should I get a working answer.
Re: html report does not work
This now seems to be working again in Ranorex v10.5.4.
When I first looked at the v10.5.4 release notes I didn't notice the below line - I thought it only had the one line about switching off PDF report creation, so I had ignored the update.
But it was present when I happened to look again. So I figured I'd try it out. I have compressed reports that now open correctly, with non-zero .rxlog.data files.
When I first looked at the v10.5.4 release notes I didn't notice the below line - I thought it only had the one line about switching off PDF report creation, so I had ignored the update.
- Disabling the Mask feature no longer causes failure of test report generation
But it was present when I happened to look again. So I figured I'd try it out. I have compressed reports that now open correctly, with non-zero .rxlog.data files.
Re: html report does not work
yeah it works now
thx for the info
thx for the info