Hi,
we use Ranorex 6.2, our AUT is based on Electron
When recording the result returns the whole Path - sometimes it´s to´much and all nodes are not necessary to catch the Control in question.
It is possible to configure the record mode for this ?
thx Hannes
Path Editor
Path Editor
You do not have the required permissions to view the files attached to this post.
Re: Path Editor
Hello Johannes,
Please see the following page of the user guide: AdvancedSettings
Scroll down to "RanoreXPath generation mode:" and see if the "StepCostReduce" option gives you a path more to your liking. If the resulting path is not short enough, then you will probably have to manually change it.
Regards,
McTurtle
Please see the following page of the user guide: AdvancedSettings
Scroll down to "RanoreXPath generation mode:" and see if the "StepCostReduce" option gives you a path more to your liking. If the resulting path is not short enough, then you will probably have to manually change it.
Regards,
McTurtle
Re: Path Editor
If your element is represented by an unique id, why do you use SPY at all. Trim your xPath to only one element by using '//'
Creating an new item in your repository only takes a few seconds!
Creating an new item in your repository only takes a few seconds!
You do not have the required permissions to view the files attached to this post.
Re: Path Editor
Hi, thanks...
i´m not so firm with this tool. but for me the AUT is a black blox - so I don´t know the value of the ID. Therefore I use the SPY (Recording mode). And than it get back the whole Path. I thought there is a possibility to trim before tracking without editing manually after that.
i´m not so firm with this tool. but for me the AUT is a black blox - so I don´t know the value of the ID. Therefore I use the SPY (Recording mode). And than it get back the whole Path. I thought there is a possibility to trim before tracking without editing manually after that.