Hello
we have wpf application we use ranorex to record the application
In that first time it recognize the controls
But after same time the repository lost it controls of the application
What can be the Reason?
Best regards
Ehud
repository lost its controls
- Support Team
- Site Admin
- Posts: 12145
- Joined: Fri Jul 07, 2006 4:30 pm
- Location: Houston, Texas, USA
- Contact:
Re: repository lost its controls
Hi,
are you sure, that your application under test is in the same state when restarting your test as it was when initially starting your test?
Please make sure to fulfill this condition as the RanoreXPath of your controls might vary otherwise.
this condition can be ensured by using set-up and tear-down regionssurrounding your recordings.
For further information please have a look at following chapter of our user guide:
General Structure of a Test Suite and its Test Cases
Regards,
Tobias
Ranorex Team
are you sure, that your application under test is in the same state when restarting your test as it was when initially starting your test?
Please make sure to fulfill this condition as the RanoreXPath of your controls might vary otherwise.
this condition can be ensured by using set-up and tear-down regionssurrounding your recordings.
For further information please have a look at following chapter of our user guide:
General Structure of a Test Suite and its Test Cases
Regards,
Tobias
Ranorex Team