Ranorex Forum

Is there a way in Ranorex Recorder to Select only Mouse clicks?

We have about 3000+ of Clicks and 400+ validatings, 200+ typings and the Mouse "Move Time" is pretty slow many times.

Best Regards,
JSN

Hi,

I am not sure if I completely got the question.
Could it be that you want that just the recorded click actions should be executed?
Could you please rephrase the question?

Regards,
Markus

We wanted to edit the Move time on the Mouse Clicks only but we need only to have them selected
first.
Is there anywhere in Ranorex recorder, that you can only select mouse clicks after a record?

I'm not sure I understood your problem either, but let me guess. Do you mean that the duration time between the steps is too long? Did you try to enable the "Turbo Mode" (as shown on the attached picture)? If enabled, the Duration times are ignored and Ranorex runs the test case as fast as possible.

We only want the "Mouse Time" reduced not the "Press Time"
That the problem.

The Duration I mentioned is not the "Press time". It's the time between each scenario step, how it was recorded by recorder. If you run the test case without enabled Turbo Boost (or with replay speed factor = 1), the playback speed is exactly how it was during recording. Do you use Ranorex recorder to record your scenarios? What are the Duration times between each step?

Hello,

Yes, you can modify the 'Move Time' in properties of your action inside the Recorder.
As shown in the screenshot the 'Move Time' is 51ms but the 'Duration' is 100ms of this action.
Please take a look at the screenshot.

In order to select many mouse clicks you would need to use 'Ctrl' or 'Shift' key.

The 'Turbo Mode' executes all action as fast as possible.
Settings on 'Duration' or 'Move Time' would be ignored.

Regards,
Markus (T)