Using a Data Source against an Oracle Database
Posted: Wed May 18, 2011 8:41 pm
I made a recording and changed one of the key sequences into a module parameter. I then created a data source that connects to an Oracle 11 database and retrieves the information I need.
I then bound that data from the connector to the module variable in the recording.
I can check the data source and refresh the data/preview the data and see that the connector is retrieving the data I expect. However, when I play the recording, the data is not "keyed" and the test eventually fails. The field is left blank although Ranorex "thinks" it successfully filled the field because it tries to move on to the next step in the test.
I have been successful creating and binding global parameters, simple data tables, etc.
What am I missing as far as using this Oracle data source goes?
I then bound that data from the connector to the module variable in the recording.
I can check the data source and refresh the data/preview the data and see that the connector is retrieving the data I expect. However, when I play the recording, the data is not "keyed" and the test eventually fails. The field is left blank although Ranorex "thinks" it successfully filled the field because it tries to move on to the next step in the test.
I have been successful creating and binding global parameters, simple data tables, etc.
What am I missing as far as using this Oracle data source goes?