ReportToPDF Module Not Found Error
Posted: Tue Aug 03, 2021 7:51 pm
Good afternoon.
I have been using ReportToPDF for a while and it's been working good until just recently. I'm not sure what caused it to stop working but here are my steps.
I put some files in the bin/debug folder that is part of the project folder. I don't think that's what caused the issue but it happened around this time. I didn't delete any of the files in the debug folder as far as I know, though, I just added some new ones, so I don't think that could have caused this issue... I'm not sure what else that I did could have caused the problem though...
After the problem started, I was getting 23 warnings every time I ran my test telling me that there were issues with the module. It said "ReporttoPDFModule could not be found. Could not load file or assembly "Ranorex.Core, Version=9.3.20."
After that I decided to update my Ranorex to version 10 but now I am getting this error instead: "Rethrow Exception within PDF Module (Necessary for correct error value)."
The module is there on the testsuite and I have the automation helpers loaded on the left panel, so I'm not sure what it's unable to find now. I don't think I deleted anything.
Any help would be appreciated, thank you.
I have been using ReportToPDF for a while and it's been working good until just recently. I'm not sure what caused it to stop working but here are my steps.
I put some files in the bin/debug folder that is part of the project folder. I don't think that's what caused the issue but it happened around this time. I didn't delete any of the files in the debug folder as far as I know, though, I just added some new ones, so I don't think that could have caused this issue... I'm not sure what else that I did could have caused the problem though...
After the problem started, I was getting 23 warnings every time I ran my test telling me that there were issues with the module. It said "ReporttoPDFModule could not be found. Could not load file or assembly "Ranorex.Core, Version=9.3.20."
After that I decided to update my Ranorex to version 10 but now I am getting this error instead: "Rethrow Exception within PDF Module (Necessary for correct error value)."
The module is there on the testsuite and I have the automation helpers loaded on the left panel, so I'm not sure what it's unable to find now. I don't think I deleted anything.
Any help would be appreciated, thank you.