Page 1 of 1

Device not getting recognized in Ranorex Studio after reboot

Posted: Wed Jun 26, 2013 8:07 am
by kunwar
Hi,
I need to reboot my Android device during test. This reboot is done via some cmd. After reboot I can connect to device via "adb" command but my device does not get recognized in Ranorex Studio. When I "refresh" in "Add device" then this is recognized. This is blocking my tests. Please let me know how to achieve "refresh" programmatically. Is there some fucntion which can do the same thing as being done by refresh action.

Thanks

Re: Device not getting recognized in Ranorex Studio after reboot

Posted: Thu Jun 27, 2013 3:29 pm
by Support Team
Hello,

Could you please provide more information about your issue?
What do you mean with 'refresh in Add device'?
Ranorex Studio has a dialog 'Mobile Devices' where you can verify the connection to your device.
Is your device available or just disconnected in this dialog?
If your device is disconnected in this dialog, you should still be able to replay your recordings since another connection is used for that process.

Regards,
Markus (T)