Page 1 of 1

Report Level

Posted: Thu Dec 15, 2011 1:37 pm
by omayer
what does it do when I select Report level as Failure
ReportLevel.jpg

Re: Report Level

Posted: Thu Dec 15, 2011 5:01 pm
by Support Team
Hi,

Add 1:
Specifies the level of report shown with the report file; by default the level of report is set to 'Inherit' which means that the test case inherits the setting from its parent (test case or test suite).
If you select "Failure" such failed actions/failure messages are shown/saved in the report file, but just such failure messages are logged, other messages like info ones are blocked and not saved to the report file.
For instance if a validation goes wrong such a failure message is logged and the test case is shown as "Failed".

Add 2:
You can also customize the report, therefore you can select your own XSL file, for more information take a look at the specific blog.

Regards,
Markus
Ranorex Support Team