Page 1 of 1

Line Numbers in Report?

Posted: Thu Sep 19, 2013 3:27 pm
by tgagel
Hello all.

I primarily use Recording Modules and, when viewing the test in Ranorex Studio, each action is numbered sequentially. Is there any easy way to get that number to display in the report? If not, it would be very helpful if the action numbers showed in the default report (enhancement?) for debugging an other purposes.

Thanks.

Todd

Re: Line Numbers in Report?

Posted: Fri Sep 20, 2013 3:54 pm
by Support Team
Hello Todd,

If you are using Ranorex Studio to run your tests you can use the "Jump to item" button in order to jump to the specific action directly. If it is not possible to jump to the action (because you are using the Test Suite Runner) you can also use the "Jump to item" button. In that case a new dialog will appear where you can find the number of the action in question.

Regards,
Bernhard

Re: Line Numbers in Report?

Posted: Fri Sep 20, 2013 4:14 pm
by tgagel
Ah! I was using reports output to html so I didn't see 'Jump to Item' buttons. Thanks for the tip!

Todd