Page 1 of 1

Data file or transformation not found.

Posted: Thu Oct 24, 2013 10:14 am
by taoyang987
after the report is created,it shows the message"Data file (XXXXX.rxlog.data) or transformation not found."so i updated ranorex from 4.1.0 to 4.1.1,but the problem remains。 i copy the report files to an other computer,the report shows well.

Re: Data file or transformation not found.

Posted: Fri Oct 25, 2013 10:49 am
by Support Team
Hi,

I assume you started your tests in Ranorex Studio and after the test finished the report poped up stating that the *.rxlog.data file cannot be found, is this right?
May I ask you to answer the following questions?
Did you manually stop the execution?
Was the test run successful?
Do you have the same problems when you open older reports with Studio?
Can you open the specific report with the report viewer?
Does this just happen with specific reports or with all of the generated ones?

Thanks,
Markus

Re: Data file or transformation not found.

Posted: Sat Oct 26, 2013 2:56 am
by taoyang987
thank you for your advice.i'll try it.