Run, Run to Cursor, break -Efficient Use of Ranorex function
Posted: Wed Feb 26, 2014 9:41 pm
If I may, I have several questions I would like to role up on this one topic entry.
I start by saying that I like the capability of running/executing an rxrec module, after applying corrections, by clicking on the “Run Play” button.
I would like to ask, and mind you I searched the Forum and searched the “User Guide,” but did not find the answer; is the a button whereby the TestSuite is executed to the end from any given rxrec module? I am now down to ¾ editing of the test cases, but in order to find the next recording with an error I have to execute the entire ¾. I would like to continue from where I found the last error.
Is there a soft key/keyboard key for “Run to the Cursor” function? While one has to place the cursor at the line one wish to execute to, one also has to “right click” to select the “Run to the Cursor” function. It be nice to place the cursor with the mouse and strike the soft key with the other hand.
Now about the Break function. When recording a test scenario using the “mouse,” when running the test scenario, Ranorex has control of the mouse. In order for the “Pause/Ctrl+Alt+B” function to work, the focus has to be gained by the “Studio,” thus fighting with the test case executing over control of the mouse. It would be nice if the “Ctrl+Alt+B” would work while the test case is executing. This there any other method to “pause” the test execution?
Also, when the test is running, there is a delay timer which is displayed. At the bottom there is; " * Press "Pause" to abort, Shift Pause to skip delays. I tried this and they did not work.
While on a role; is there a way of setting the "Debug Layout" as the "default" setting? Or, might there be a key sequence to toggle between the now "Default Layout" and the "Debug Layout."
Any comments are greatly appreciated.
will
I start by saying that I like the capability of running/executing an rxrec module, after applying corrections, by clicking on the “Run Play” button.
I would like to ask, and mind you I searched the Forum and searched the “User Guide,” but did not find the answer; is the a button whereby the TestSuite is executed to the end from any given rxrec module? I am now down to ¾ editing of the test cases, but in order to find the next recording with an error I have to execute the entire ¾. I would like to continue from where I found the last error.
Is there a soft key/keyboard key for “Run to the Cursor” function? While one has to place the cursor at the line one wish to execute to, one also has to “right click” to select the “Run to the Cursor” function. It be nice to place the cursor with the mouse and strike the soft key with the other hand.
Now about the Break function. When recording a test scenario using the “mouse,” when running the test scenario, Ranorex has control of the mouse. In order for the “Pause/Ctrl+Alt+B” function to work, the focus has to be gained by the “Studio,” thus fighting with the test case executing over control of the mouse. It would be nice if the “Ctrl+Alt+B” would work while the test case is executing. This there any other method to “pause” the test execution?
Also, when the test is running, there is a delay timer which is displayed. At the bottom there is; " * Press "Pause" to abort, Shift Pause to skip delays. I tried this and they did not work.
While on a role; is there a way of setting the "Debug Layout" as the "default" setting? Or, might there be a key sequence to toggle between the now "Default Layout" and the "Debug Layout."
Any comments are greatly appreciated.
will