Ranorex Forum

Hi to all,

I know that RowCOunt exists as command, but I don't have the option, anyway if I write the command it works as expected.

Regards,

Hi,

I believe the reason why you don't see the RowCount (and some other) table attributes is, that this attribute is from "Dynamic" section of attributes. These are only available, if the element in question is loaded and reachable by Ranorex. Just make sure the table you are working with is loaded while you adding the Validation step. Then you should see also many other attributes in that combo

Hi wlijo,

In some cases not all available attributes are loaded and shown in this drop down, but you can update those values by clicking the "Highlight Element" item in the context menu as shown below
Hope this information helps.

Regards,
Markus (S)